TM 55-6115-491-40
SECTION IV
FINAL TEST PROCEDURES
4-3.
Set up the generator for testing as shown in
4-1.
TEST SETUP.
4-2.
Mechanical Test Setup.
Figure 4-1. Mechanical Test Setup for Generator.
regulator, and control panel shall be 77+27F (25 15
a. Air must be supplied to the generator for
cooling during tests. Supply air through a thin wall tube
C).
at a pressure of 1.6 inches of water (static plus velocity
d. Cooling air shall not be 90F (5 C) higher or
head) measured 12 inches from the entrance to the
lower than the existing ambient temperature.
radial air scoop.
4-4.
Electrical Test Setup.
b. The air inlet temperature shall be 77 f:
4-5.
The electrical test setup for the generator is
27F (25 15 C).
shown in figure 4-2. Test equipment required for
generator is listed in table 2-1.
c. The ambient temperature for the generator,
4-1
