ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
Figure 4-54. Fuel Injection Pump Mounting Flange
COOLING FAN COVER.
a.
Inspection.
(1) Shut down generator set.
(2) Inspect cooling fan cover for security, cracks, corrosion, and other damage.
b.
Removal.
(1) Shut down generator set.
(2) Remove air cleaner cover, refer to paragraph 4.12.2.a.
(3) Remove capscrews (Figure 4-55), washers, couplings, rubber retainers, cooling fan
cover with recoil starter assembly, and seal from engine.
(4) If necessary, remove recoil starter assembly, refer to paragraph 4.54.b.
c.
Repair.
WARNING
CARC paint dust is a health hazard. Wear protective eyewear,
mask, and gloves when sanding CARC painted surfaces.
Failure to comply can cause personal injury.
(1) Remove all loose paint.
(2) Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3) Repaint surface in accordance with TM 43-0139/TO 35-1-3.
