TM 9-6115-650-14&P
Figure 4-8. Switch Box Replacement.
b. Installation.
(1) Position switch box (7) on fender (3).
(2) Working underneath fender (3) insert four screws (4), four flat washers (5) and four Iockwashers (6)
through fender and into switch box (7) and tighten.
(3) Connect power cables (1) to load terminals on generator sets (2). (Refer to paragraph 4-1, a(12).)
4-25. Switch Box Repair.
WARNING
Make sure generator set circuit breakers are in OFF position before performing any
repairs on switch box. Failure to observe this precaution may result in injury or death by
electrocution.
a.
Load Term
inal and Terminal Board Replacement. (See figure 4-9.) There are four load terminals on the
switch box terminal board. This procedure is typical for all four. When reconnecting wires, refer to the schematic
inside the switch box (figure 4-7) and to the identification bands on the wires.
4-20
