TM 9-6115-650-14&P
4-19. Accessory Box Replacement. (See figure 4-5). The power plant is equipped with an accessory
box which is mounted to the trailer bed between the front and rear generator sets.
Figure 4-5. Accessory Box Replacement.
a. Removal.
(1) Remove four screws (1), eight Iockwashers (2), and four nuts (3) securing accessory box (4) to trailer
bed (5).
(2) Lift accessory box (4) off trailer bed (5).
b. Installation.
(1)
(2)
(3)
Position accessory box (4) on trailer bed (5).
Insert four screws (1) with Iockwashers (2) through accessory box mounting brackets and trailer bed (5).
Working under trailer, install one flat washer (2) and one nut (3) on each screw (1). Tighten hardware to
secure accessory box (4).
4-20. Fire Extinguisher Bracket Replacement. (See figure 4-6.) Each of the two fire extinguishers
supplied with the power plant is carried in a bracket. One bracket is mounted on each fender. Replacement
procedures described below are the same for both brackets.
a. Removal.
(1) Remove four screws (1), eight flat washers (2) and four nuts (3) securing bracket (4) to fender (5).
(2) Remove bracket (4) from fender (5).
4-16
