TM 9-6115-650-14&P
Section Vlll. MAINTENANCE OF POWER PLANT TRAILER
4-17. General. This section of the manual contains unit level maintenance procedures for components of the
M103A3 trailer added when the trailer is used as part of the AN/MJQ-25 power plant. These components are not
covered in the overall trailer maintenance manual. When power plant has been previously painted in camouflage,
any touch-up painting following repairs must match authorized patterns and colors as specified in TB 43-0147.
Camouflage painting shall be done in accordance with MIL-C-53072. For all other unit maintenance procedures
on the trailer, refer to TM 9-2330-213-14&P
WARNING
Before performing any maintenance that requires climbing on or under trailer, set trailer
handbrakes, chock both wheels, and lower rear leg prop. Injury to personnel could result
from trailer suddenly rolling or tipping.
4-18. Fuel Can Bracket Replacement. (See figure 4-4.) There are four fuel can brackets supplied with
the AN/MJQ-25. Two brackets are mounted on top of each fender. Replacement procedures described below are
typical for all four.
Figure 4-4. Fuel Can Bracket Replacement.
a. Removal.
(1) Remove four screws (1), four nuts (2) and four flat washers (3) securing bracket (4) to fender (5).
(2) Remove bracket (4) from fender (5).
b. Installation.
(1) Position fuel can bracket (4) on fender (5).
(2) Insert four screws (1) down through bracket (4) and through fender (5).
(3) Install one washer (3) and one nut (2) on each screw (1). Tighten hardware to secure bracket (4).
4-15
