ARMY TM 9-6115-639-13
AIR FORCE TO 35C2-3-386-51
MARINE CORPS TM 10155A-13/1
4-22. CIRCUIT INTERRUPTER INDICATOR LIGHT MAINTENANCE
This task covers removal, inspection, and installation.
INITIAL SETUP
Tools:
Equipment Condition:
Tool Kit, General Mechanics Automotive
Generator set shut down (Para. 2-9)
(Item 2, App. B, Sect. III)
Battery cables disconnected
Soldering Iron (Item 6, App. B, Sect. III)
Cable disconnected for SLAVE RECEPTACLE
Heat Gun (Item 7, App. B, Sect. III)
Parts / Materials:
Solder (Item 12, App. E)
Heat Shrink Tubing (Item 13, App. E)
A. REMOVAL.
1.
Turn quarter-turn fasteners (7, Figure 4-13) to
unlock control panel (2).
2.
Replace indicator light bulb (3) by removing cap
(4) from CIRCUIT INTERRUPTER indicator
light (5). Unscrew bulb (3) from light (5).
3.
Peel back heat shrink tubing to expose electrical
wires on rear of indicator light (5). Using a
soldering iron, detach electrical wires from rear of
indicator light.
4.
Remove indicator light (5) from control panel (2)
by removing attaching nut (6) and lockwasher
(1).
B. INSPECTION.
1.
Inspect indicator light for corrosion and obvious
damage.
2.
Inspect electrical wiring for cuts, crimps, bare
wire, or other damage. Ensure connectors are
securely attached.
Figure 4-13. CIRCUIT INTERRUPTER
Indicator Light (Sheet 1 of 2)
4-44