TM 9-6150-228-13&P
NOTE
Record the order of disassembly and note direction of connector parts as they are
removed.
(3) Slide connector body (1), two glands, (2 and 3) wire mesh (4), and gland nut (5) off cable (6).
(4) Replace defective parts.
When installing both connectors on a length of bulk cable, the wire colors must match
the pin/socket positions. Refer to Appendix G for proper connector configuration.
c. Crimp tool setup procedure.
(1) Position Teflon washer in regulator and install regulator on air tank Tighten connection.
(2) Apply teflon tape or pipe compound to threads on air hose and install air hose in regulator. Tighten
connection.
NOTE
The crimper can be set up for operation by either the crimper handle or the foot control
pedal. For handle (hand) operation, do step (3). For pedal (foot) operation, do step (4).
(3) Set up crimper for hand operation, as follows:
(a)
Remove plug from rear of crimper handle and install plug in center of rear casting.
(b)
Apply thread sealant to, and install, the 1/4inch NPT coupler in rear of crimper handle. Tighten
coupler.
(c)
Install the male, quick-disconnect fitting in coupler. Tighten fitting in coupler.
(d)
Install air hose from regulator onto quick disconnect fitting.
5-27
