TM 9-6150-228-13&P
NOTE
When properly installed, die should sit flat against retainer face.
(10) Install retaining ring on crimper and tighten by hand.
(11) To operate crimper, slide pin or socket into the locator with the wire attached. Using button on crimper
handle, or foot pedal, as applicable, activate crimper until crimp is complete. Then, release air pressure and remove pin
or socket.
d.
Install connector parts.
(1)
Install gland nut (5), wire mesh (4), glands (3 and 2), and connect body (1) on cable (6).
(2)
Cut and remove proper length of insulation from outer cable jacket and wires. Refer to Appendix G.
(3)
Using multimeter, perform continuity test (Table 4-5) to determine correct pin-to-wire installation.
(4)
Tag wires with colored tape (Items 9 through 13, Appendix E) in accordance with Appendix G.
5-29
