TM 9-6115-729-24
0100
CAUTION
All fittings and openings must be capped or plugged immediately after opening to prevent
contamination of the fuel, oil, or air system.
NOTE
Cut tiedown straps as required during removal. Install tiedown straps as required during
installation. Table 1 identifies removal and installation steps for engine sensors.
REMOVAL
FIGURE 1
REMOVAL
INSTALLATION
RELATED
NAME
ITEM
STEPS
STEPS
WP
Injector actuation pressure
1
1 and 2
29 and 30
sensor
3 and 4
27 and 28
Oil temperature sensor
2
5 and 6
25 and 26
Turbo outlet temperature sensor
3
7 and 8
20 thru 24
Magnetic speed pickup
4
9 and 10
18 and 19
Engine oil pressure sensor
6
11 thru 13
15 thru 17
Coolant temperature sensor
7
14 thru 16
12 and 14
WP 0056 and
Fuel pressure sensor
8
17 and 18
9 thru 11
Engine timing sensors
10
19 and 20
7 and 8
Atmospheric pressure sensor
11
21 and 22
5 and 6
Low coolant sensor
12
23 and 24
3 and 4
Turbo inlet pressure sensor
13
25 and 26
1 and 2
Intake manifold air temperature
14
sensor
1. Tag and disconnect engine harness connector ENG-P13 from the injector actuation pressure sensor.
2. Remove the injector actuation pressure sensor (Figure 1, Sheet 1, Item 1) by unscrewing the sensor.
3. Tag and disconnect engine harness connector ENG-P18 from the oil temperature sensor.
4. Remove the oil temperature sensor (Figure 1, Sheet 1, Item 2) by unscrewing the sensor.
