TM 9-6115-729-24
0100
REMOVAL - Continued
9. Tag and disconnect engine harness connector ENG-P15 from the engine oil pressure sensor.
10. Remove the engine oil pressure sensor (Figure 1, Sheet 1, Item 6) by unscrewing the sensor.
11. Drain level of coolant below the coolant temperature sensor (Figure 1, Sheet 1, Item 7) (WP 0067).
12. Tag and disconnect engine harness connector ENG-P6 from the coolant temperature sensor.
13. Remove the coolant temperature sensor (Figure 1, Sheet 1, Item 7) by unscrewing the sensor.
14. Drain sufficient fuel from system so fuel does not spill during removal of the fuel pressure sensor (WP 0056).
15. Tag and disconnect engine harness connector ENG-P17 from the fuel pressure sensor.
16. Remove the fuel pressure sensor (Figure 1, Sheet 1, Item 8) by unscrewing the sensor.
17. Tag and disconnect engine harness connectors ENG-P4 and ENG-P5 from the engine timing sensors.
18. Remove bolt (Figure 1, Sheet 1, Item 9) and two engine timing sensors (Figure 1, Sheet 1, Item 10). The
engine timing sensors pull out after the bracket bolt is removed.
19. Tag and disconnect engine harness connector ENG-P11 from the atmospheric pressure sensor.
20. Remove the atmospheric pressure sensor (Figure 1, Sheet 2, Item 11).
21. Tag and disconnect ECM to EMCP harness connector ENG-P16 from the low coolant sensor.
22. Remove the low coolant sensor (Figure 1, Sheet 2, Item 12) by unscrewing the sensor.
23. Tag and disconnect ECM to EMCP harness connector ENG-P8 from the turbo inlet pressure sensor.
24. Remove the turbo inlet pressure sensor (Figure 1, Sheet 2, Item 13).
25. Tag and disconnect engine harness connector ENG-P7 from intake manifold air temperature sensor.
26. Remove the intake manifold air temperature sensor (Figure 1, Sheet 2, Item 14) by unscrewing the sensor.
END OF TASK
0100-5
