TM 9-6115-729-24
0100
INSTALLATION
1. Install the intake manifold air temperature sensor (Figure 1, Sheet 2, Item 14). Screw in and torque sensor to
11-19 lb-ft (15-25 Nm).
2. Remove tag and connect engine harness connector ENG-P7 to the intake manifold air temperature sensor.
3. Install the turbo inlet pressure sensor (Figure 1, Sheet 2, Item 13) by screwing in.
4. Remove tag and connect ECM to EMCP harness connector ENG-P8 to the turbo inlet pressure sensor.
5. Install the low coolant sensor (Figure 1, Sheet 2, Item 12) by screwing in.
6. Remove tag and connect ECM to EMCP harness connector ENG-P16 to the low coolant sensor.
7. Install the atmospheric pressure sensor (Figure 1, Sheet 2, Item 11). Screw in and torque sensor to
72-108 lb-in (8-12 Nm).
8. Remove tag and connect engine harness connector P11 to the atmospheric pressure sensor.
NOTE
Engine timing sensors must be replaced as a pair.
9. Ensure sensors are properly seated on flanges.
10. Install the two engine timing sensors (Figure 1, Sheet 1, Item 10) and install bolt (Figure 1, Sheet 1, Item 9).
11. Remove tag and connect engine harness connectors ENG-P4 and ENG-P5 to the engine timing sensors.
Perform Engine Timing Sensor Calibrate (WP 0013, SYMPTOM 11).
12. Install the fuel pressure sensor (Figure 1, Sheet 1, Item 8) by screwing in.
13. Remove tag and connect engine harness connector ENG-P17 to the fuel pressure sensor.
14. Refill fuel system as required (WP 0016).
15. Install the coolant temperature sensor (Figure 1, Sheet 1, Item 7). Screw in and torque sensor to 11-19 lb-ft
(15-25 Nm).
16. Remove tag and connect engine harness connector ENG-P6 to the coolant temperature sensor.
17. Refill cooling system to the correct level (WP 0067).
18. Install the engine oil pressure sensor (Figure 1, Sheet 1, Item 6). Screw in and torque sensor to 72-108 lb-in
(8-12 Nm).
19. Remove tag and connect engine harness connector ENG-P15 to the engine oil pressure sensor.
20. Align a ring gear tooth directly in the center of the threaded sensor opening.
21. Screw the magnetic speed pickup (Figure 1, Sheet 1, Item 4) into hole until end contacts gear tooth.
22. Turn the magnetic speed pickup (Figure 1, Sheet 1, Item 4) counterclockwise (CCW) 270 degrees (three-
fourths turn.
0100-6
