TM 9-6115-729-24
0101
REMOVAL - Continued
5. Remove 14 bolts (Figure 1, Item 12), washers (Figure 1, Item 13), valve cover manifold (Figure 1, Item 9),
and gasket (Figure 1, Item 14).
END OF TASK
CLEANING
1. Remove remaining gasket material from cylinder head, top and bottom surfaces of valve cover manifold
(Figure 1, Item 9), and mating surface of valve cover (Figure 1, Item 5).
WARNING
Cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract. Skin and eye
protection are required when working in contact with cleaning solvent. Avoid repeated or
prolonged contact. Work in ventilated area only. Failure to comply can cause injury or death to
personnel.
2. Clean all parts thoroughly before installing.
END OF TASK
INSTALLATION
1. Apply bead of sealing compound to both sides of new gasket (Figure 1, Item 14).
2. Install gasket (Figure 1, Item 14), valve cover manifold (Figure 1, Item 9), fourteen washers (Figure 1, Item 13),
and bolts (Figure 1, Item 12). Using the illustrated sequence, torque bolts (Figure 1, Item 12) to 79-133 lb-in
(9-15 Nm).
3. Connect plug (Figure 1, Item 10) to each of six unit injectors (Figure 1, Item 11). Connect unit injector plug to
wiring harness.
4. Apply bead of silicone sealant to both sides of new gasket (Figure 1, Item 8).
5. Install gasket (Figure 1, Item 8), valve cover (Figure 1, Item 5), 14 washers (Figure 1, Item 7), and bolts
(Figure 1, Item 6). Using the illustrated sequence, torque bolts (Figure 1, Item 6) to 79-133 lb-in (9-15 Nm).
6. Install gasket (Figure 1, Item 4), breather (Figure 1, Item 3), washer (Figure 1, Item 2), and bolt (Figure 1,
Item 1).
END OF TASK
END OF WORK PACKAGE
0101-3/4 blank
