ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
DEPROCESSING CHECKSHEET
WARNING
Exhaust discharge contains deadly gases. Do not operate generator set in enclosed area
unless exhaust discharge is properly vented outside. Position as far away from
personnel, shelters, and occupied vehicles as possible. Failure to observe this warning
could result in severe personal injury or death due to carbon monoxide poisoning.
Generator sets weight 123 to 144 lbs. Use suitable lifting device or four-man lift.
Place the generator set on a level site if possible. Provide enough clearance around the
generator set to allow for normal operation and maintenance functions.
1. Deprocessing Inspection.
TM 9-6115-673-13&P is the source reference unless otherwise noted.
1.1 Remove all packaging material.
1.2 Inspect identification plate for positive identification of generator set.
1.3 At a minimal inspect the following items on the generator set for missing hardware,
looseness or any damage that may have occurred during shipment,
Frame:
Ground Strap (figure 4-32)
Ground Stud (figure 4-63)
Frame assembly (figure 4-64)
Control Panel exterior and interior:
Meters (figure 2-1)
Instrument cover (figure 4-21)
Voltage adjust potentiometer (figure 4-27)
Fuses (figure 4-31)
Receptacles (figure 4-33)
Start-preheat/preheat/off/start rotary switch (figure 4-34)
NATO slave receptacle (figure 4-36)
Load terminals (figure 4-37)
On-off load circuit breaker (figure 4-40)
Electrical wiring (typical) (figure 4-44)
Load terminal board cover (figure 4-45)
Ground strap (figure 4-32)
Assembly (figure 5-39 AC Alternator/figure 5-42 DC Alternator)
M-2
