ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
WASHER
LOCKNUT
c. Installation.
CAUTION
Ground stud terminal shears off easily if locknut is
overtightened. Do not overtorque locknut.
(1) Apply corrosion preventive compound (Item 5, Appendix E) on frame contact points
and install ground stud terminal (Figure 4-63) in generator set frame with washer
and locknut. Hold terminal body hex with wrench. Torque locknut to 35 lbs-in.
(3.95 Nm) from bottom. Apply insulating electrical compound (Item 22, Appendix
(2) Connect ground wire to ground stud terminal as necessary.
FRAME.
a. Inspection.
(1) Inspect frame (Figure 4-64) for chipped paint, and other damage.
(2) Inspect threaded inserts for debris and damage.
b. Repair.
WARNING
CARC paint dust is a health hazard. Wear protective
eyewear, mask, and gloves when sanding CARC
painted surfaces.
Failure to comply can cause
personal injury.
