ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
e. Installation.
(1) Route alternator wiring harness (Figure 4-61) as removed. Use new cable ties to
secure harness where required.
(2) Connect alternator wiring harness as tagged. Remove tags.
(3) Connect wiring harness ground lead to alternator and attach wiring harness resistor
to mounting bracket with capscrews, screws, lockwashers, washers, and nut.
(4) Connect alternator wiring harness plug to receptacle on bottom of control panel.
4.60
PREHEATER LEAD.
a. Inspection.
(1) Shut down generator set.
(2) Visually inspect preheater lead for cracked or deteriorated insulation, broken
terminals, and other damage.
b.
Testing.
(1) Shut down generator set.
(2) Set multimeter for ohms and check for continuity between air intake heating
elements stud and cylinder head bolt connecting preheater lead to ground.
(3) If necessary, repair preheater lead.
c.
Removal.
(1) Shut down generator set.
(2) Remove nut (Figure 4-62) and disconnect preheater lead at stud on air intake
heating elements. Then remove bolt, washer, and lockwasher securing other
terminal of preheater lead to diesel engine.
(3) Cut tie wraps as necessary and remove preheater lead.
d.
Repair. Replace individual connectors or assemble complete preheater lead in accordance
with Appendix G, Figure G-12.
