ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
Figure 4-59. Starter Assembly
(2) Visually inspect engine-wiring harness wiring for cracked or deteriorated insulation,
broken terminals, and other damage.
(3) Visually inspect the engine wiring harness receptacle for security, cracks, broken
wires, and other damage.
b. Testing.
(1) Shut down generator set.
(2) Disconnect engine wiring harness plug (P2) (Figure 4-60) from receptacle on
bottom of control panel.
(3) Set multimeter for ohms and check for continuity between P2 socket A and stud on
air intake preheater (HTR2), P2 socket B and LOP switch (S1), P2 socket C and
starter solenoid switch (L5) pin C, P2 socket D and starter solenoid switch (L5) pin
S, P2 socket E and diesel engine dynamo, and P2 socket F and diesel engine
dynamo.
(4) If necessary, repair wiring harness. Then connect plug to receptacle on bottom of
control panel.
