ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
(2)
Turn crankshaft to Top Dead Center (TDC), position bearings in connecting rod and cap. Apply
lubricating oil (Item 14, Appendix E) to nuts before installation. Then install bolts, washers, and
nuts. Apply lubricating oil (Item 14, Appendix E) to nuts and torque to 13-15 lbs-ft (18-20 Nm).
(3)
Install cylinder head, refer to paragraph 5.13.c.
(4)
Install crankcase cover, refer to paragraph 5.16.c.
FLYWHEEL.
a. Removal.
(1)
Shut down generator set.
(2)
Remove cooling fan cover, refer to paragraph 4.53.b.
(3)
Remove starter pulley from flywheel, refer to paragraph 4.54.b.
(4)
Install flywheel locking handle (Figure 5-29).
(5)
Remove nut (Figure 5-30) and washer securing flywheel to crankshaft.
(6)
Using flywheel extractor, remove flywheel from crankshaft (Figure 5-31).
(7)
Remove key from crankshaft.
