ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
(3)
Inspect oil seals for tears and other damage.
(4)
Inspect bearings for excessive play, signs of overheating, scoring, and other damage.
(5)
Measure inside diameter of crankcase cover bearing [1.1811 - 1.1862 in. (30 - 30.13 mm)].
(6)
Measure inside diameter of crankcase cover bearing housing, only if bearing has to be
removed, [1.3386 - 1.3396 in. (34.000 - 34.025 mm)].
(7)
Measure outside diameter of cylinder block side bearing [2.8341 - 2.8346 in. (71.987 - 72.000
mm)].
(8)
Measure inside diameter of cylinder block bearing housing [2.8343 - 2.8350 in. (71.9905 -
72.0095 mm)].
(9)
Replace damaged or worn parts.
c. Installation.
(1)
If removed, install rear bearing (Figure 5-32) in crankcase cover (Figure 5-33).
(2)
If removed, install rear oil seal in crankcase cover to depth of 0.1575 in. (4 mm) below surface of
cover.
(3)
If removed, install front oil seal in cylinder block so seal is flush with surface of block.
(4)
If removed, install front bearing on crankshaft.
