ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-180
NOTE
Cylinder bracket assembly is located on the inside wall of the generator housing and
cannot be adequately inspected when installed.
(3)
Remove ether cylinder, step a above.
(4)
Inspect cylinder bracket assembly (8, Figure 4-27) for cracks, corrosion, stripped or damaged
threads, and other damage.
(5)
Shake ether cylinder, and listen for liquid. If there is little or no sound of liquid in cylinder, replace
cylinder.
(6)
Install ether cylinder assembly, step c below.
c. Installation.
(1)
Install bolts (9, Figure 4-27), cylinder bracket assembly (8), washers (7), lockwashers (6), and nuts
(5) on generator set housing.
(2)
Remove cap (4) from ether solenoid valve (3).
(3)
Insert ether cylinder (2) through cylinder bracket assembly (8), and screw cylinder into ether
solenoid valve (3).
(4)
Close clamp of cylinder bracket assembly (8), and tighten wingnut (1).
(5)
Close engine compartment access doors.
4.11.8 Ether Solenoid Valve L6.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
__________
WARNING
DC voltages are present at generator set electrical components even with
generator shut down. Avoid shorting any positive terminal with
ground/negative. Failure to comply can cause injury to personnel and damage
to equipment.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Open right side engine compartment access doors (Figure 1-2).
(4)
Tag and disconnect electrical leads from ether solenoid valve (3, Figure 4-27).
(5)
Disconnect tube assembly (10) from adapter (19) and spray nozzle (11).
(6)
Loosen wingnut (1), and unscrew ether cylinder (2) from ether solenoid valve (3).
(7)
Install cap (4) on ether solenoid valve (3).
