ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-177
(5)
With fuel level sender arm resting freely in what would be an empty position, multimeter should
indicate between 216 and 264 ohms.
(6)
Move fuel level sender arm up to what would be a full position. Multimeter should indicate
between 29.7 and 36.3 ohms.
(7)
Replace fuel level sender if indications are not as above.
(8)
Install fuel level sender, step d below.
d. Installation.
(1)
Remove cover from fuel tank opening.
(2)
Thoroughly clean mating surfaces for new gasket (40, Figure 4-26). Ensure no foreign material
enters fuel tank. Apply sealant (Item 21, Appendix E) to both sides of gasket. Position gasket on
fuel tank.
(3)
Position fuel level sender (39) in fuel tank. Ensure float is in same position as removed.
(4)
Remove tag from electrical lead (38), and secure fuel level sender (39) and lead to fuel tank with
washers (37), lockwashers (36), and bolts (35).
(5)
Remove tag, and install electrical lead (34) on fuel level sender (39).
(6)
Close engine compartment access doors.
(7)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.11.6 Fuel Pickup.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), disconnect negative battery cable from battery.
(3)
Open right side engine compartment access doors (Figure 1-2).
(4)
Disconnect hose (41, Figure 4-26) from adapter (47).
NOTE
Mark position of fuel pickup before removing.
(5)
Remove screws (42), lockwashers (43), washers (44), fuel pickup (45), and gasket (46) from fuel
tank.
(6)
Remove adapter (47) from fuel pickup (45).
(7)
Cover opening in fuel tank.
b. Inspection.
