ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-181
(8)
Remove nuts (12), lockwashers (13), washers (14), relay (16), and bolts (15) from generator set
housing.
(9)
Remove bolts (17) from bracket (18) and remove solenoid (3) from bracket.
(10) Remove adapter (19) from solenoid (3).
(11) Remove spray nozzle (11) from engine intake manifold.
(12) Close engine compartment doors.
b. Inspection.
(1)
Remove ether solenoid valve, step a above.
(2)
Inspect ether solenoid valve (3, Figure 4-27) for cracks, corrosion, damaged threads, and other
damage.
(3)
Inspect tube assembly (10) for cracks, breaks, pinching, damaged threads, and other damage.
(4)
Inspect spray nozzle (11) for cracks, corrosion, clogging, and other damage.
(5)
Replace any defective parts.
(6)
Install ether solenoid valve, step c below.
c. Installation.
(1)
Open right side engine compartment access doors (Figure 1-2).
(2)
Install spray nozzle (11, Figure 4-27) on engine intake manifold.
(3)
Install adapter (19) into solenoid (3).
(4)
Install solenoid (3) to bracket (18) with bolts (17).
(5)
Install relay (16), bolts (15), washers (14), lockwashers (13), and bolts (12) on generator set
housing.
(6)
Remove cap (4) from ether solenoid valve (3).
(7)
Insert ether cylinder (2) through cylinder bracket assembly (8), and screw cylinder into ether
solenoid valve (3).
(8)
Close clamp of cylinder bracket assembly (8), and tighten wingnut (1).
(9)
Connect tube assembly (10) to adapter (19) and spray nozzle (11).
(10) Connect electrical leads to ether solenoid valve (3). Remove tags.
(11) Connect negative battery cable to battery, and close BATTERY ACCESS door.
(12) Close engine compartment access doors.
