ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-182
4.11.9 Ether Solenoid Relay.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open right side engine compartment access doors (Figure 1-2).
(3)
Inspect ether solenoid relay (16, Figure 4-27) for cracks, loose mounting and other damage.
(4)
Replace damaged parts.
(5)
Close engine compartment access doors.
b. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open battery access door (Figure 1-2) and disconnect negative battery cable.
(3)
Open right side engine access doors.
(4)
Tag and disconnect electrical wires from ether solenoid relay (16).
(5)
Remove nut (12), lockwasher (13), washer (14), bolt (15), and ether solenoid relay (16).
c. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Tag and disconnect electrical leads to the ether solenoid relay (16, Figure 4-27) and remove from
generator set.
(3)
Set multimeter for ohms, and connect leads between terminals 85 and 86, and check for an
indication of 288 to 352 ohms.
(4)
If indications are other than above, relay is defective and must be replaced.
(5)
Attach electrical leads to ether solenoid relay K24 (16) and remove tags.
d. Installation.
(1)
Install ether solenoid relay (16, Figure 4-27) with bolts (15), washers (14), lockwashers (13), and
nuts (12).
(2)
Attach electrical leads to ether solenoid relay (16) and remove tags.
(3)
Connect negative battery cable to battery, and close battery access door (Figure 1-2) and right side
engine access doors (Figure 1-2).
4.11.10 Fuel Filter/Water Separator.
a. Inspection.
