ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-175
c. Installation.
(1)
Position fuel fill hose (27, Figure 4-26), clamps (25 and 26), and filler neck (24) on fuel tank.
(2)
Secure filler neck (24) to filler neck panel with bolts (23) and locknuts (22).
(3)
Tighten hose clamps (25 and 26).
(4)
Install reducer (21), washer (20), and seal nut (19) on side of filler neck (24).
(5)
Install connector (18) on reducer (21).
(6)
Position hose clamp (16) on hose (17). Connect hose to connector (18), and tighten hose clamp.
(7)
Install filler neck tube and cap assembly (15) in filler neck (24).
(8)
Close engine compartment access doors.
(9)
Close fuel drain valve (30), install cap (28), and service fuel tank. Refer to Table 4-2 for proper
fuel.
(10) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.11.4 Fuel Drain Valve.
Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Open left side engine compartment access doors (Figure 1-3).
(4)
Remove cap (28, Figure 4-26) from adapter (29).
__________
WARNING
Diesel fuel is flammable and toxic to eyes, skin, and respiratory tract. Skin and
eye protection are required when working in contact with diesel fuel, and avoid
repeated or prolonged contact. Failure to comply can cause injury or death to
personnel.
(5)
Open fuel drain valve (30), and drain fuel into a suitable container.
(6)
Remove adapter (29) from fuel drain valve (30), and fuel drain valve from elbow (31).
(7)
If necessary, remove elbow (31) and connector (32) from fuel tank fitting.
(8)
If removed, install connector (32) and elbow (31) on fuel tank fitting.
(9)
Install fuel drain valve (30) on elbow (31), and adapter (29) on fuel drain valve.
