TM 9-6115-664-13&P
4-29. REMOTE CONTROL CABLE MAINTENANCE
B.
TESTING.
Conduct continuity check of remote control cable using a digital multimeter.
C.
INSPECTION.
1
Inspect remote cable electrical connector for damage. Inspect connector for corrosion, damage, and evidence of
electrical short. Check for bent, broken, or missing pins.
2.
Inspect electrical wiring for cuts, abrasions, and bare wire. Inspect wire insulation for damage.
3.
Inspect wiring connectors for bent, broken, or missing electrical contacts.
D.
INSTALLATION.
1.
Install halves of four rubber isolators (16, Figure 4-19) onto remote housing (2). Mate vehicle mounting plate (11) to
housing and secure using four screws (13), washers (14, 15), and locknuts (12)
2.
Feed electrical connector and wiring through hole in bottom of remote housing (2). Mate flanged plug (6) to housing
and secure using four screws (9) and locknuts (10).
3.
Connect remote receptacle (7) to plug (8).
4.
Connect remote cable electrical connector (6) to circuit board assembly.
5.
Mate front panel (1) to remote housing (2) and secure using six screws (3), lockwashers (4), and washers (5).
4-73
