TM 9-6115-664-13&P
4-29. REMOTE CONTROL CABLE MAINTENANCE
This task covers removal, testing, inspection, and instillation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Remote Cable Disconnected From
and Repair (Item 1, App. B)
Local Control Panel Assembly
A. REMOVAL.
CAUTION
Use care when separating remote
control front panel from housing to
prevent damage to electrical wiring.
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Remove front panel (1, Figure 4-19) from remote
housing
(2)
by
removing
six
screws
(3),
lockwashers (4), and washers (5).
2.
Disconnect remote cable electrical connector (6)
from circuit board assembly.
3.
Disconnect remote receptacle (7) from electrical
plug (8).
4.
Remove electrical plug (8) from remote housing (2)
by removing four screws (9) and locknuts (10).
Feed electrical connector and wire through hole in
bottom of housing.
5.
Remove vehicle mounting plate (11) from remote
housing (2) by removing four locknuts (12), screws
(13), and washers (14, 15). Separate halves of
rubber isolators (16).
Figure 4-19. Remote Control Cable
4-72
