TM 9-6115-664-13&P
4-27. LAMP TEST SWITCH MAINTENANCE (REMOTE CONTROL PANEL)
2.
Inspect electrical wiring for cuts, abrasions, and bare wire. Inspect wire insulation for damage.
C.
TESTING.
1.
Carefully peel back shrink-wrap to expose terminals on rear of lamp test switch (7).
2.
Press switch and check for continuity between terminals. Replace as required.
D.
INSTALLATION.
1.
Install lamp test switch (7, Figure 4-17) onto front panel (1) using attaching nut (8).
2.
Solder electrical wires to rear of lamp test switch (7).
3.
Connect remote cable electrical connector (6) to circuit board assembly.
4.
Mate front panel (1) to remote housing (2) and secure using six screws (3), lockwashers (4), and washers (5).
4-69