TM 9-6115-664-13&P
4-25. VOLTMETER MAINTENANCE (REMOTE CONTROL PANEL)
This task covers removal, inspection, testing, and installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Remote Cable Disconnected From
and Repair (Item 1, App. B)
Local Control Panel Assembly
A. REMOVAL.
CAUTION
Use care when separating remote
control front panel from housing to
prevent damage to electrical wiring.
NOTE
Discard and replace all Iockwashers
and locknuts when removed.
1.
Remove front panel (1, Figure 4-15) from remote
housing
(2)
by
removing
six
screws
(3),
lockwashers (4), and washers (5).
2.
Disconnect remote cable electrical connector (6)
from circuit board assembly.
3.
Tag and disconnect electrical wires from rear of
voltmeter (7).
4.
Remove voltmeter (7) from front panel (1) by
removing attaching nuts (8) and bracket (9).
B.
INSPECTION.
1.
Inspect meter for broken glass and damage to front
panel. Inspect electrical connectors for corrosion,
damage, and evidence of electrical short.
2.
Inspect electrical wiring for cuts, abrasions, and
bare wire. Inspect wire insulation for
Figure 4-15. Voltmeter damage.
4-64
