TM 9-6115-664-13&P
4-23. REMOTE CONTROL CONNECTOR MAINTENANCE (LOCAL CONTROL PANEL)
This task covers removal, inspection, testing, and installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Local Control Panel Assembly
and Repair (Item 1, App. B)
Removed ( para. 4-20)
Parts/Materials:
Adhesive, Silicon (Item 2, App. E)
A.
REMOVAL.
CAUTION
Use care when separating front panel
of control panel assembly from
enclosure to prevent damage to
electrical wiring.
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Remove front panel (1, Figure 4-13) from enclosure
(2) by removing five screws (3), lockwashers (4),
and washers (5).
2.
Tag and disconnect electrical wiring connector (11)
from circuit board assembly.
3.
Unscrew receptacle cap (6) from remote control
connector (7).
4.
Remove remote control connector (7) from front
panel (1) by removing four screws (8) and locknuts
(9).
B.
TESTING.
Conduct continuity check of remote control
connector and wiring using a multimeter.
Figure 4-13. Remote Control Connector
4-60
