TM 9-6115-664-13&P
4-27. LAMP TEST SWITCH MAINTENANCE (REMOTE CONTROL PANEL)
This task covers removal, inspection, testing, and instillation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Remote Cable Disconnected From
and Repair (Item 1, App. B)
Local Control Panel Assembly
A. REMOVAL.
CAUTION
Use care when separating remote
control front panel from housing to
prevent damage to electrical wiring.
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Remove front panel (1, Figure 4-17) from remote
housing
(2)
by
removing
six
screws
(3),
lockwashers (4), and washers (5).
2.
Tag
and
disconnect
remote
cable
electrical
connector (6) from circuit board assembly.
3.
Before disconnecting electrical wires from lamp test
switch (7), test switch in accordance with paragraph
C.
4.
Disconnect electrical wires from rear of lamp test
switch (7).
5.
Remove lamp test switch (7) from front panel (I) by
removing attaching nut (8).
B.
INSPECTION.
1.
Inspect lamp test switch for corrosion or other
obvious damage. Inspect electrical connectors for
corrosion, damage, and evidence of electrical short.
Figure 4-17. Lamp Test Switch
4-68