TM 9-6115-664-13&P
4-28. CIRCUIT BOARD ASSEMBLY MAINTENANCE (REMOTE CONTROL PANEL)
This task covers removal, inspection, and instillation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Remote Cable Disconnected From
and Repair (Item 1, App. B)
Local Control Panel Assembly
A.
REMOVAL.
CAUTION
Use care when separating remote
control front panel from housing to
prevent damage to electrical wiring.
CAUTION
Wear an anti-static bracelet when
handling circuit board to prevent
damage to components.
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Remove front panel (1, Figure 4-18) from remote
housing
(2)
by
removing
six
screws
(3),
lockwashers (4), and washers (5).
2.
Disconnect remote cable electrical connector (6)
from circuit board assembly.
3.
Disconnect electrical connector (7) from circuit
board assembly (8). Remove circuit card assembly
from front panel (1) by removing five screws (9).
Figure 4-18. Circuit Board Assembly
4-70