TM 9-6150-228-13&P
5-10
ELECTRICAL LEADS.
This task covers:
Repair
INITIAL SETUP
Tools
Equipment Conditions
Crimp Tool, Pin Socket.
Reference
Crimp Tool Kit, Pneumatic
Para 4.20 MS Connectors removed.
(Item 3, Appendix B).
Materials/Parts
General Safety Instructions
Connector (Appendix F).
Contact (Appendix F).
WARNING
Contact (Appendix F).
Cover (Appendix F).
High voltage is present in this equipment during
operation. Do not attempt making any repairs
Personnel Required
without first shutting down all input power from the
Two.
power distribution panel. Failure to observe this
warning could result in serious injury or death.
REMOVAL
a. Disassemble Connector.
NOTE
Nut (1) has a left-hand thread.
(1) Unscrew and remove nut (1) from connector (2).
(2) Remove, as an assembly, wires (3), rear support group (4), and forward support group (5).
(3) Remove forward support group (5) from sockets (6).
(4) Remove sockets (6) from rear support group (4), refer to Tables G-1 and G-2, Appendix G for proper
removal tool.
b. Replace Defective Parts.
(1) Refer to paragraph 5-14. Cable Assemblies, for connector socket replacement procedures. The procedures
for replacing sockets or pins are identical. Paragraph 5-14 describes use of the pneumatic crimp tool
system.
(2) To determine correct wire length, wire insulation color, correct stripping of wire, refer to Table 4-6. For
correct selection of pin/sockets and wiring, refer to the appropriate figure in Appendix F. These figures
provide the necessary information to repair or fabricate the cables.
5-20
