TM 9-6150-226-13
4-16 PHASE INDICATOR LIGHT ASSEMBLY AND BULB. (cont)
Disconnect phase light wiring
from bus bar.
Invert circuit breaker panel.
Loosen and remove hardware (1).
Lift out phase indicator
light assembly (Z) from front
of panel.
Disconnect phase light wiring
from bus bars.
Remove screws (3), nuts (4)
and washers (5) from light bracket
mounting (6).
Remove nut (7) and washer (8)
from phase indicator light (9).
Lift out phase indicator
light (9) from light bracket mounting
(6).
c.
NOTE
If you have PDISE equip-
ment, follow instructions
in paragraph 3d, e, f, g and
h.
Insert phase indicator
light (2) through front of
panel.
Install and tighten hard-
ware (1) on phase indicator
light.
Connect phase light wiring
to bus bar.
FOLLOW-ON MAINTENANCE:
Install cover panel,
circuit breaker panel,
and lanyards (para 4-14).
2. REMOVE PHASE INDICATOR LIGHT ASSEMBLY.
a.
b.
c.
d.
g.
h.
3. INSTALL NEW PHASE INDICATOR LIGHT.
a.
b.
4-46
Change 1
