TM 9-6115-730-24
DIRECT SUPPORT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 200 kW, 50/60 Hz MEP-809A/PU-809A
GENERATOR REPLACEMENT
INITIAL SETUP:
Equipment Condition (cont.)
Tools and Special Tools
Lifting Device, 2,600 lb (1180 kg) Capacity
Right rear door assembly removed
Shop Equipment, Automotive Maintenance,
Right rear door assembly (latch) removed
Shop Equipment, Field Maintenance, Basic
Front roof section housing assembly
Rear roof section housing assembly
Personnel Required
Engine generator compartment ceiling
Two
Generator access cover assembly removed
References
Rear section housing assembly removed
TM 9-6115-730-24P
Right rear panel assembly removed
Equipment Condition
Left rear panel assembly removed
Left rear door assembly (latch) removed
WARNINGS
Metal jewelry will conduct electricity. All jewelry can become entangled in generator set
components. Remove all jewelry when working on generator set. Failure to comply can cause
injury or death to personnel by electrocution.
DO NOT wear loose clothing when performing checks, services and maintenance. Failure to
comply can cause injury or death to personnel.
High voltage is produced when this generator set is in operation. Make sure unit is completely shut
down and free of any power source before attempting any repair or maintenance on the unit.
Failure to comply can cause injury or death to personnel.
High voltage is produced when the generator set is in operation. Never attempt to start or
maintain the generator set unless it is properly grounded. Failure to comply can cause injury or
death to personnel.
DC voltages are present at generator set electrical components even with generator set shut
down. Avoid shorting any positive with ground/negative. Failure to comply can cause injury to
personnel and damage to equipment.
0095-1