TM 9-6115-730-24
UNIT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 200 kW, 50/60 Hz MEP-809A/PU-809A
REAR SECTION HOUSING ASSEMBLY MAINTENANCE
INITIAL SETUP:
Equipment Condition
Tools and Special Tools
Control box assembly removed (WP 0042)
Tool Kit, General Mechanic's (WP 0123, Item 1)
Generator access cover assembly removed
Materials/Parts
Left rear door assembly (latch) removed
Foam damping sheet (WP 0124, Item 11)
Right rear door assembly (latch) removed
Personnel Required
Winterization heater control box assembly
removed, if applicable (WP 0089)
One
Rear roof section housing assembly removed
References
Potential transformers PT2 and PT3 removed
TM 9-6115-730-24P
WARNINGS
Metal jewelry will conduct electricity. All jewelry can become entangled in generator set
components. Remove all jewelry when working on generator set. Failure to comply can cause
injury or death to personnel by electrocution.
DO NOT wear loose clothing when performing checks, services and maintenance. Failure to
comply can cause injury or death to personnel.
High voltage is produced when this generator set is in operation. Make sure unit is completely shut
down and free of any power source before attempting any repair or maintenance on the unit.
Failure to comply can cause injury or death to personnel.
High voltage is produced when the generator set is in operation. Never attempt to start or
maintain the generator set unless it is properly grounded. Failure to comply can cause injury or
death to personnel.
REMOVAL
1. Remove three screws (Figure 1, Item 1), lockwashers (Figure 1, Item 2), and washers (Figure 1, Item 3).
2. Remove two screws (Figure 1, Item 4), lockwashers (Figure 1, Item 5), and washers (Figure 1, Item 6).
3. Remove six screws (Figure 1, Item 7), lockwashers (Figure 1, Item 8), and washers (Figure 1, Item 9).
0035-1
