TM 9-6115-730-24
0034
NOTE
DISASSEMBLY should not be done until front section housing assembly has been removed.
DISASSEMBLY
1. Remove six screws (Figure 1, Sheet 2, Item 15), lockwashers (Figure 1, Sheet 2, Item 16), washers (Figure 1,
Sheet 2, Item 17), and vane assembly (Figure 1, Sheet 2, Item 18).
2. Remove fourteen screws (Figure 1, Sheet 2, Item 19), lockwashers (Figure 1, Sheet 2, Item 20), washers
(Figure 1, Sheet 2, Item 21), and plate assembly (Figure 1, Sheet 2, Item 22).
3. Remove seven screws (Figure 1, Sheet 2, Item 23), lockwashers (Figure 1, Sheet 2, Item 24), washers
(Figure 1, Sheet 2, Item 25), and bracket (Figure 1, Sheet 2, Item 26).
4. Remove fourteen screws (Figure 1, Sheet 2, Item 27), lockwashers (Figure 1, Sheet 2, Item 28), washers
(Figure 1, Sheet 2, Item 29), and two brackets (Figure 1, Sheet 2, Item 30).
5. Remove 8 screws (Figure 1, Sheet 1, Item 5), lockwashers (Figure 1, Sheet 1, Item 6), washers (Figure 1,
Sheet 1, Item 7), nuts (Figure 1, Sheet 1, Item 8) and door flanges (Figure 1, Sheet 1, Item 9).
6. Remove three foam damping sheets as required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sheets as templates to cut new foam damping sheets.
2. Install door flanges (Figure 1, Sheet 1, Item 9) and secure with 8 screws (Figure 1, Sheet 1, Item 5),
lockwashers (Figure 1, Sheet 1, Item 6), washers (Figure 1, Sheet 1, Item 7), and nuts (Figure 1, Sheet 1,
Item 8).
3. Install three foam damping sheets.
4. Install two brackets (Figure 1, Sheet 2, Item 30), fourteen washers (Figure 1, Sheet 2, Item 29), lockwashers
(Figure 1, Sheet 2, Item 28), and screws (Figure 1, Sheet 2, Item 27).
5. Install bracket (Figure 1, Sheet 2, Item 26), seven washers (Figure 1, Sheet 2, Item 25), lockwashers
(Figure 1, Sheet 2, Item 24), and screws (Figure 1, Sheet 2, Item 23).
6. Install plate assembly (Figure 1, Sheet 2, Item 22) and secure with fourteen washers (Figure 1, Sheet 2,
Item 21), lockwashers (Figure 1, Sheet 2, Item 20), and screws (Figure 1, Sheet 2, Item 19).
7. Install vane assembly (Figure 1, Sheet 2, Item 18) and secure with six washers (Figure 1, Sheet 2, Item 17),
lockwashers (Figure 1, Sheet 2, Item 16), and screws (Figure 1, Sheet 2, Item 15).
END OF TASK
0034-4
