TM 9-6115-730-24
0035
DISASSEMBLY
1. Remove four nuts (Figure 1, Item 13), washers (Figure 1, Item 14), screws (Figure 1, Item 15), locking ring
(Figure 1, Item 16), bushing (Figure 1, Item 17), retainer plate (Figure 1, Item 18), spacer (Figure 1, Item 19),
and sleeve (Figure 1, Item 20).
2. Remove eight foam damping sheets as required.
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sheets as templates to cut new foam damping sheets. Install eight foam
damping sheets.
2. Install sleeve (Figure 1, Item 20), spacer (Figure 1, Item 19), retainer plate (Figure 1, Item 18), bushing
(Figure 1, Item 17), locking ring (Figure 1, Item 16), four screws (Figure 1, Item 15), washers (Figure 1, Item
14), and nuts (Figure 1, Item 13).
END OF TASK
INSTALLATION
1. Install rear section housing assembly (Figure 1, Item 21) and secure with the following
a. Four screws (Figure 1, Item 10), lockwashers (Figure 1, Item 11), and washers (Figure 1, Item 12).
b. Six screws (Figure 1, Item 1), lockwashers (Figure 1, Item 2), and washers (Figure 1, Item 3).
c.
Two screws (Figure 1, Item 4), lockwashers (Figure 1, Item 5), and washers (Figure 1, Item 6).
d. Three screws (Figure 1, Item 7), lockwashers (Figure 1, Item 8), and washers (Figure 1, Item 9).
2. If removed, install winterization kit control box assembly (WP 0089).
3. Install generator access cover assembly (WP 0033).
4. Install control box assembly (WP 0041).
5. Install right rear door assembly (latch) (WP 0028).
6. Install left rear door assembly (latch) (WP 0023).
7. Install control box door panel assembly (WP 0020).
8. Install rear roof section housing assembly (WP 0031).
END OF TASK
END OF WORK PACKAGE
0035-3/4 blank
