TM 9-6115-730-24
UNIT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 200 kW, 50/60 Hz MEP-809A/PU-809A
LEFT REAR PANEL ASSEMBLY MAINTENANCE
INITIAL SETUP:
Tools and Special Tools
Personnel Required
Tool Kit, General Mechanic's (WP 0123, Item 1)
One
Materials/Parts
References
Foam damping sheet (WP 0124, Item 11)
TM 9-6115-730-24P
WARNINGS
Metal jewelry will conduct electricity. All jewelry can become entangled in generator set
components. Remove all jewelry when working on generator set. Failure to comply can cause
injury or death to personnel by electrocution.
DO NOT wear loose clothing when performing checks, services and maintenance. Failure to
comply can cause injury or death to personnel.
High voltage is produced when this generator set is in operation. Make sure unit is completely shut
down and free of any power source before attempting any repair or maintenance on the unit.
Failure to comply can cause injury or death to personnel.
High voltage is produced when the generator set is in operation. Never attempt to start or
maintain the generator set unless it is properly grounded. Failure to comply can cause injury or
death to personnel.
REMOVAL
Remove seven screws (Figure 1, Item 1), six screws (Figure 1, Item 2), 13 washers (Figure 1, Item 3), 13
lockwashers (Figure 1, Item 4), and left rear panel assembly (Figure 1, Item 5).
END OF TASK
DISASSEMBLY
Remove three foam damping sheets as required.
END OF TASK
ASSEMBLY
If necessary, use old foam damping sheets as templates to cut new foam damping sheets. Install foam damping
sheets.
END OF TASK
0039-1
