ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
(2)
If removed, install rear bearing in crankcase cover so bearing is flush with surface of cover.
(3)
Install balancer shaft in cylinder block.
(4)
Align timing marks on gears, Figure 5-21.
(5)
Install crankcase cover, refer to paragraph 5.16.c.
PISTON AND CONNECTING ROD ASSEMBLY.
a. Removal.
(1)
Shut down generator set.
(2)
Remove crankcase cover, refer to paragraph 5.16.a.
(3)
Remove cylinder head assembly, refer to paragraph 5.13.a.
(3)
Remove nuts (Figure 5-22), washers, and cap from connecting rod.
(4)
Rotate crankshaft to top of stroke, and pull piston and connecting rod out top of cylinder block.
b. Disassembly.
(1)
Remove bolts (Figure 5-22) from connecting rod.
CAUTION
Use piston ring remover to remove piston rings. Never stretch piston rings.
(2)
Using piston ring remover, remove barrel face ring, tapered face ring, and oil ring from piston.
