ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
ELECTRICAL LEAD WIRE (S) (TYPICAL).
a.
Inspection.
(1) Shut down generator set.
(2) Release instrument panel by turning fastener, open instrument panel slowly.
(3) Visually inspect control panel electrical leads for cracked or deteriorated insulation,
broken terminals, and other damage.
(4) Close and secure instrument panel.
b.
Testing.
(1) Shut down generator set.
(2) Release instrument panel by turning fastener, open instrument panel slowly.
(3) Tag and disconnect control panel electrical lead (Figure 4-44).
(4) Set multimeter for ohms and check wire for continuity.
(5) Replace defective wires and electrical connectors. Refer to Appendix G, Table G-1
(MEP-531A) or Table G-2 (MEP-501A), for instructions on how to make each
electrical lead.
(6) Connect control panel electrical lead as tagged. Remove tags.
(7) Close and secure instrument panel.
c.
Removal.
(1) Shut down generator set.
(2) Release instrument panel by turning fastener, open instrument panel slowly.
(3) Tag and disconnect control panel electrical lead (Figure 4-44) from terminals.
d.
Installation.
(1) Connect control panel electrical lead (Figure 4-44) as tagged. Remove tags.
(2) Close and secure instrument panel.
