ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-128
(1)
As necessary, remove components from auxiliary control bracket (18, Figure 4-16), paragraphs
4.8.26 through 4.8.31.
_________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(2)
Repair all dents and cracks, and remove loose paint.
(3)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(4)
Repaint surfaces in accordance with TM 43-0139.
(5)
Install components removed in step (1), paragraphs 4.8.26 through 4.8.31.
d. Installation.
(1)
Install terminals (20, Figure 4-16) and screws (19) on auxiliary control bracket (18).
(2)
Install auxiliary control bracket (18) and bolts (17) on floor of DCS control box assembly.
(3)
Install auxiliary control bracket components, paragraphs 4.8.26 through 4.8.31.
(4)
Install DCS control box top panel, paragraph 4.7.2.
(5)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.33 VOLTAGE SELECTION Switch S20.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Inspect VOLTAGE SELECTION switch (23, Figure 4-16) for loose connections and mounting
hardware and other damage.
(4)
Install DCS control box top panel, paragraph 4.7.2.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Remove jamnut (21), lockwasher (22), and VOLTAGE SELECTION switch (23) from bracket (18).
(5)
Tag and disconnect electrical leads from VOLTAGE SELECTION switch (23, Figure 4-16).
