ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-127
(7)
If any indications are other than above, replace resistor.
(8)
Install DCS control box top panel, paragraph 4.7.2.
(9)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
c. Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Tag and desolder electrical leads from resistor (13, Figure 4-16).
(5)
Remove nuts (11), lockwashers (12), resistor (13), sleeving (14), screws (15), and lockwashers (16)
from auxiliary control bracket (18).
(6)
Install lockwashers (16), screws (15), sleeving (14), resistor (13), lockwashers (12), and nuts (11)
on auxiliary control bracket (18).
(7)
Solder electrical leads to resistor (13). Remove tags.
(8)
Install DCS control box top panel, paragraph 4.7.2.
(9)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.32 Auxiliary Control Bracket.
a. Inspection.
Inspect auxiliary control bracket (18, Figure 4-16) for dents, cracks, loose paint, and corrosion.
b. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Remove auxiliary control bracket components, paragraphs 4.8.26 through 4.8.31.
(5)
Remove bolts (17, Figure 4-16) and auxiliary control bracket (18) from floor of DCS control box
assembly.
(6)
Remove screws (19) and terminals (20) from auxiliary control bracket (18).
c. Repair.
