ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-125
(9)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
c. Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
NOTE
Soldering applies only to CR1. All other diodes are installed with screws.
(4)
For CR2-CR10, tag and remove diode from unit. Refer to Schematic FO-1.
(5)
Tag and desolder electrical leads from terminals (20, Figure 4-16).
(6)
Desolder diode (9) from terminals (20).
(7)
Solder diode (9) to terminals (20).
(8)
Solder electrical leads to terminals (20). Remove tags.
(9)
Install CR2-CR10 and remove tags. Refer to Schematic FO-1.
(10) Install DCS control box assembly, paragraph 4.8.1.
(11) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.30 Resistor R1.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Inspect resistor (10, Figure 4-16) for cracks, breaks, corrosion, bent terminals, and other damage.
(4)
Install DCS control box top panel, paragraph 4.7.2.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.
(4)
Tag and remove R1 (10, Figure 4-16).
