ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-23
(6)
Secure generator to engine flywheel housing with washers (41), lockwashers (40), and bolts
(39). Torque bolts to 25 ft-lb (33.9 Nm).
(7)
Install band cover (35), washers (34), screws (33), lockwashers (32), and nuts (31) on generator
case.
(8)
Detach lifting device from generator lifting eye.
(9)
Install engine and generator assembly, paragraph 5.4.2.
5.5
MAINTENANCE OF DCS CONTROL BOX ASSEMBLY.
__________
WARNING
When disconnecting or removing batteries, disconnect the negative lead
that connects directly to the grounding stud first. Disconnect the negative
end of the interconnection cable next. When installing batteries, reverse the
connection sequence. Failure to comply can cause serious personal injury.
5.5.1
DCS Control Box Wiring Harness.
CAUTION
Electronic components containing printed circuit boards are extremely
sensitive to electrostatic discharge (ESD). Wear an ESD wrist strap
connected to ground whenever coming in contact with ESD-sensitive
components. Failure to comply can cause severe damage to equipment.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Attach ESD wrist strap and connect to ground.
(4)
Inspect DCS wiring harness for burned, bent, corroded, and broken terminals. Refer to Figure 4-
16.
(5)
Inspect connectors for cracks, corrosion, stripped threads, bent or broken pins, and obvious
damage.
(6)
Inspect wire insulation for burns, deterioration, and chafing.
(7)
Disconnect ESD wrist strap, and remove wrist strap.
(8)
Install DCS control box top panel, paragraph 4.7.2.d.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box top panel, paragraph 4.7.2.a.
