ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-21
5.4.3
Engine/Generator Disassembly.
NOTE
Refer to engine manual TM 9-2815-259-24 for information concerning repair of
the engine.
NOTE
When removing generator only, refer to paragraph 5.10.
a. Old Component Removal Prior to Installation.
The following components may not be supplied with the new engine and must be removed from the old
engine. Install on the new engine prior to its installation in the generator set.
(1)
Remove governor actuator (if replacing the engine).
(2)
Remove temperature sender.
(3)
Remove oil pressure sensor.
(4)
Remove engine coolant drain cock.
(5)
Remove speed sensor and bushing.
(6)
Remove dead crank switch bracket.
(7)
Remove engine legs on bell housing.
(8)
Remove cable on fuel injector pump and bracket.
(9)
Remove bracket for fan guards.
(10) Remove radiator and brackets.
(11) Remove breather, breather hoses, heaters and insulation.
(12) Remove ether injector.
(13) Remove oil drain from oil pan.
(14) Remove fan blade and extension hub.
(15) Remove bracket clamp bolts.
(16) Remove fuel pump fittings.
(17) Remove oil sampling valves.
b.
Compare New and Old Engine.
Compare new and old engines. Remove components unique to the old engine and install
these on the new engine prior to installation in the generator set.
