ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-20
(25) Connect ether tube.
(26) Connect wiring harness wires at battery. Remove tags.
(27) Connect crankcase ventilation hose heater wires (4). Remove tags.
(28) Connect battery charging alternator output wire. Install battery charging alternator current
sensor bracket to alternator.
(29) Tighten hose clamp (Figure 4-25, 25) to fuel collar fill hose (27).
(30) Connect auxiliary pump output line and cap (Figure 4-25).
(31) Connect fuel rail return line and cap (Figure 4-25).
(32) Plug in auxiliary fuel pump, P13.
(33) Plug in magnetic pickup, P12.
(34) Plug in electric actuator, P10.
(35) Connect oil pressure sender (4.13.1). Remove tag.
(36) Connect fuel float switch (paragraph 4.11.5). Remove tag.
(37) Install dead crank switch and saved washers (paragraph 4.13.4).
(38) Connect fuel water separator drain line.
(39) Connect coolant overflow bottle drain line and install bracket to engine.
(40) Connect engine coolant drain hose at engine petcock (Figure 4-22).
(41) Connect radiator drain hose (paragraph 4.10.7).
(42) Install air filter assembly, refer to paragraph 4.9.2.
(43) Install top housing section, refer to paragraph 4.7.3.
(44) Install DSC control box, refer to paragraph 4.7.2.
(45) Service engine lubrication system, paragraph 3.3.7.
(46) Service coolant system, paragraph 3.3.4.
(47) Connect negative battery cable to battery, and close BATTERY ACCESS door.
(48) Start generator set, paragraph 2.11.1. Check for proper operation.