TM 9-6115-650-14&P
Figure 4-13. Ground Wire Replacement.
(2) Installation.
(a)
(b)
(c)
Install switch box ground wire terminal (14) on AC GROUND terminal E2 (13) and secure with flat
washer (12) and nut (11).
Install other switch box ground wire terminal (10) on load terminal LO (8). Install power cable ground
(white) wire terminals (9) on terminal LO and secure both wires with flat washer (7) and nut (6).
Position cover (4) on switch box (5) and secure with 16 screws (1), 16 Iockwashers (2) and 16 flat
washers (3).
4-26. Taillight Cable Assembly and Electrical Lead Repair and Replacement. One taillight
cable assembly and one electrical lead connect each taillight to the trailer wiring harness. The taillight cable
assembly and electrical lead are replaced by unplugging four connectors at each end. Repair is accomplished by
replacing defective connectors. To manufacture a replacement cable assembly and electrical lead, install new
connectors on suitable lengths of insulated wire using the procedure described for repair.
a. Male Connector Replacement. (See figure 4-14.)
(1) Slide shell (1) back on wire lead (2).
(2) Remove washer (3).
(3) Slide shell (1) off over contact (4).
4-27
