TM 9-6115-647-14&P
Figure 4-10. J1 Wiring Harness Replacement.
b.
J6 Wiring Harness Replacement. (See figures 4-9 and 4-11).
(1) Removal.
(a) Release cover latch and open PDU cover.
(b) Detach J6 wiring harness wires from terminal board TB1 (1, figure 4-11).
(c) Remove all tiedown straps binding J6 harness wires to J1 harness wires.
(d) Remove two nuts (2) and open two clamps (3) Remove J6 wires.
(e) Remove four screws (4), four flat washers (5) and four nuts (6) and pull wiring harness out of PDU
housing (7). Remove gasket (8).
(f)
Unscrew and remove connector cover (9) from connector J6 (10).
(2) Installation.
(a) Slide gasket (8) over harness wires and up against flange of connector (10).
(b) Feed wires through J6 opening in PDU housing (7).
4-34
