Figure 4-13. P8 Wiring Harness Replacement.
P9 Wiring Harness Replacement. (See figures 4-9 and 4-14).
(a) Release cover latch and open PDU cover.
(b) Remove nut (1, figure 4-14) and open clamp (2) Remove four P9 harness wires.
(c) Detach P9 wiring harness wires from terminal board TB1 (3).
(d) Unplug connector P9 (4) from connector J9 on contactor K2 (5).
(a) Plug connector P9 (4) into connector J9 on contactor K2 (5).
(b) Using figure 4-9 for wire routing information, connect harness wires to terminal board TB1 (3).
(c) Route wires through clamp (2) and install nut (1).
(d) Close and secure PDU cover.