ARMY TM 9-6115-639-13 AIR FORCE TO 35C2-3-386-51 MARINE CORPS TM 10155A-13/1 4-26.  GOVERNOR CONTROL MAINTENANCE This task covers removal, inspection, and installation. INITIAL SETUP Tools: Equipment Condition: Tool Kit, General Mechanic’s Automotive Generator set shut down (Para. 2-9) (Item 2, App. B, Sect. III) Battery cables disconnected Cable disconnected for SLAVE RECEPTACLE A.    REMOVAL. 1. Turn  quarter-turn  fasteners  to  unlock  and  open control panel. 2. Tag    and    disconnect    electrical    wiring    from governor control (1, Figure 4-17). 3. Remove governor control (1) from inside wall of control   box   by   removing   screw   and   captive washer assemblies (2). B.    INSPECTION. 1. Inspect  governor  control  for  corrosion,  evidence of electrical short, and obvious damage. 2. Inspect  electrical  wiring  for  cuts,  crimps,  bare wire,  or  other  damage.    Ensure  connectors  are securely attached. 3. Remove   and   replace   any   component   that   is damaged  to the extent that it will effect the safe operation of the generator set. Figure 4-17.  Governor Control C.    INSTALLATION. 1. Mate governor control (1, Figure 4-17) to  inside wall  of  control  box.    Secure  using  screws  and   captive washer assemblies (2). 2. Connect electrical wiring to governor control (1). 3. Close   control   panel   and   lock   in   place   using quarter-turn fasteners. 4-52