TM5-6115-640-14&P
Each fire extinguisher supplied with the power plants is carried in a bracket.
The bracket is mounted on the fender on the roadside of AN/MJQ-32 and curbside for AN/MJQ-33. The bracket is
mounted upright on the AN/MJQ-32 and on its side for the AN/MJQ-33. Replacement procedures described below are
the same for each bracket of either power plant. Shown is the bracket for AN/MJQ-33.
a.
Removal.
(1)
Remove four screws (1, figure 4-15), flat washers (2) and nuts (3) securing bracket (4) to fender (5).
(2)
Remove bracket (4) from fender (5).
b.
Installation.
(1)
Position fire extinguisher bracket (4) on fender (5).
(2)
Insert four screws (1) through bracket and fender.
(3)
Install one flat washer (2) and nut (3) on each screw (1). Tighten hardware to secure bracket.
Figure 4-15. Fire Extinguisher Bracket Replacement.
4-49